The Anycubic Vyper comes with a 0.4mm nozzle as standard, which means the lowest layer height you can realistically get away with is 0.1mm. Just set it going, come back in 5 minutes, and you’re ready to print.Īt a default, you’ll be printing at 0.2mm layer height. You normally have to do this manually, using a sheet of paper and a bunch of adjustable knobs to raise and lower each corner of the print bed. Set the machine going and it will automatically test the print bed at 16 different points to make sure it’s level. With that done, the only thing left to do before you start printing is to level the bed, which is where the Anycubic Vyper deploys its secret weapon - it has auto-bed levelling. It does the job, but it's one of the few obvious signs that you're dealing with a cheaper 3D printer. The Anycubic Vyper has a spool holder, but it’s a bit basic, which is a shame. The default material that you’ll be printing with is PLA, which is sold in spools. The instructions that come with the Anycubic Vyper walk you through this stage clearly and simply, so you shouldn’t have any issues here. Once you’ve set everything up and got it plugged in, you’ll need to install the filament.

It’s easy to use, and the menus are all straightforward to navigate. You can run set up and maintenance programs on it, or you can use it to set prints going. There is a touch screen attached to the front of the device that you can use to operate it. You’ll need to mount the arch to the base using several deep screws - this isn’t difficult, but it might be easier with two people as you’ll need someone to hold everything in place while you install the screws. This isn’t like a Prusa kit where you need to build it from scratch. The Anycubic Vyper requires some assembly out of the box, but it’s much simpler than some 3D printers out there. Auto levelling is huge quality of life feature.Check out the Anycubic Vyper at Anycubic's webstore.If you’re looking to get into 3D printing, the Anycubic Vyper is a fantastic first choice, while still also offering plenty to experience printers. Most 3D printers need many hours of dialing in specific settings to get great prints, and we just didn’t find that at all with the Anycubic Vyper. The print quality is great too, especially with the out of the box settings.

It has a huge print bed that allows you to print large models in a single piece, and it’s super easy to use. This is the type of device that most people think of when they think about 3D printers.įor the cost you’re paying, the Anycubic Vyper offers a lot. This means it uses a roll of plastic filament and extrudes melted plastic out of the print head, building up layers one at a time. The Anycubic Vyper is a Fused Deposition Modeling (FDM) 3D printer.

Kissol setup anycubic plus 3dlabprint